The same electrician
You deal with Abbass from the first call to the finished electrical work. No call centre.
Split-system installation, replacement and fault finding in Wadalba. AB Electrical’s qualified in-house team handles the electrical and refrigeration work, with the room, unit positions and existing supply assessed together.
NSW electrical contractor licence 354068C. Check the register (NSW licence check, opens in a new tab)

The right setup depends on the room, unit positions, drainage, pipe routes and available power supply. AB’s own qualified team handles the refrigeration and electrical work for split-system installations.
For a replacement, we assess the existing unit positions, connections and supply rather than assuming everything can be reused. A new room, extension or renovation may need a different arrangement. We explain the installation work and any circuit or switchboard changes before it is booked.

You deal with Abbass from the first call to the finished electrical work. No call centre.
Abbass started as an electrician in 1988 and set up AB Electrical in 2014.
NSW electrical contractor licence 354068C, held by Abbass, and insured. Level 2 supply work is done as an Accredited Service Provider.
If a fault is caused by our installation or repair workmanship, we return and put it right at no extra charge.
A problem may be in the air conditioner, its isolator, the wiring or the circuit protection. Tripping does not prove that a circuit is too small, and replacing the unit may not fix an electrical fault.
We test the equipment and installation to identify the cause, then explain the repair needed or whether replacement should be considered. Do not repeatedly reset a tripping breaker or open equipment covers.
The written quote for planned installation identifies the equipment and work included. Electrical and refrigeration requirements are considered together.
Discuss heating and cooling needs, unit positions, pipe routes, drainage and access.
Establish the circuit, isolation and any switchboard work needed for the selected system.
Complete the agreed unit installation, refrigeration and electrical connections.
Test and commission the installation, then explain operation and controls at handover.
Repairs, lighting, powerpoints, fans, data and smart switching, plus the electrical side of solar and battery systems for your home.
Faults, fit-outs, three-phase work and electrical testing, with site access and power interruptions planned around the job.
Repairs, replacement boards and safety-switch protection, based on the condition and capacity of the existing installation.
Meter moves, consumer mains, supply upgrades and defect notices, with the relevant distributor or metering requirements checked.
Tell us what needs doing and add photos if you can take them safely. We reply to talk through the work and, for planned jobs, a written quote.
Discuss a new split system, a replacement unit or an air conditioner that is not working properly. Leave a repeatedly tripping unit off and arrange assessment.